So the voltage which rises after disconnection of the battery is that of the single capacitor shown on the diagram, which was initially in parallel with the battery?
2010/3/22 Harry Veeder <[email protected]>: > The capacitor is on the input side. > A pick up coil was added later to see if it is possible to close the loop and > generate OU. > > He tried in test 10 but didn't succeed: > http://www.youtube.com/watch?v=c7CsBr7ouPE > > harry > > > > ----- Original Message ---- >> From: Stephen A. Lawrence <[email protected]> >> To: [email protected] >> Sent: Sun, March 21, 2010 2:51:23 PM >> Subject: Re: [Vo]:circuit diagram >> >> Harry will need to confirm this, but I believe the diagram in question > is >> only for the "input" side. The "output" side, which isn't >> shown, > consists of a pickup coil, some related circuitry, and >> the > aforementioned capacitors. > > If I'm wrong, then I'm confused (no >> great surprise there). > > > > On 03/21/2010 11:56 AM, Michel Jullian >> wrote: >> Wait a minute, I see no cap attached to the output on Harry's >> diagram >> "photo 2"discussed here (haven't followed the other >> discussions), only >> one capacitor on the input side, in parallel with the >> battery until >> the latter is disconnected, which BTW isn't explained on >> the diagram. >> Is the diagram not complete? >> >> >> >> 2010/3/21 Stephen A. Lawrence < >> href="mailto:[email protected]";>[email protected]>: >>> >>> >>> >> On 03/21/2010 09:55 AM, Michel Jullian wrote: >>>> Which >> voltage? >>> >>> Volts on the caps attached to the output -- >> right, Harry? >>> >>> But the signal generator is still hooked >> up, and it's coupled to the >>> output (at least) through the gate >> capacitance of the FET and the linked >>> inductors of the >> "transformer", and the signal generator's output power >>> hasn't been >> measured or even estimated. So, there's no reason to >>> believe >> this rig is doing anything other than transforming and >>> rectifying >> the output of the SG. >>> >>> As I've already said a boringly >> large number of times, this is the same >>> general sort of system as >> Stiffler's circuit, where he had a signal >>> generator capacitively >> coupled to the system, and it was driving a >>> handful of LEDs. >> The main innovation here comes from Naudin, and it's >>> the use of a >> toroidal coil as the primary with a neo magnet on the >>> outside of the >> coil which "twists" the core's field to allow the >>> toroidal coil to >> "couple" to the pickup >> coil. >>> >>> >>> >>>> >>>> >> 2010/3/20, Harry Veeder < >> href="mailto:[email protected]";>[email protected]>: >>>>> >> yes. >>>>> You are aware that the the voltage keeps rises even >> after the battery is >>>>> disconnected. >> >> > > > __________________________________________________________________ > Connect with friends from any web browser - no download required. Try the new > Yahoo! Canada Messenger for the Web BETA at > http://ca.messenger.yahoo.com/webmessengerpromo.php > >
