--- In [email protected], "Harvey D Norris" <harvich@...> wrote: Sun Sep 4, 2011 > 1)How can the totality of measured phase angles around the three phase circle be 100 degrees less then the normal 360 degrees? > 2)Where did the excess amperage found on stator lines go? I will be showing next a jpeg entitled excessive stator line amperage. this shows two out of three stator lines recieving or sending? excess of the phase amperages they serve. > 3)Why is there a division of stator voltages? this of course might be explained by the loads on the phases themselves, and how that load naturally diminishes the open circuit voltage by the ratio of R(int)/R(load). However upon disconnection and reconnection we see that induction around the phase circle occurs, meaning that phase 2 in the the phasing order of 123 has an added voltage when compared to operation from the solitary phase employed vs the connection of both phase 1 and 2. It would seem excellent to note the operation as each phase is added, this may be a planned demo. In the next video demo we will see the operation of the 666 machine with reversed magnetic fields in time, accomplished by wire reversal of each coil segment. On version one of the machine each phasing of series connected segments spirals diagonally upwards in a clockwise sense. Version two will have the top coil connected to the stator rather then the bottom one, thus the wire reversal also shows itself by the fact that now the spralling of segments in the direction is counterclockwise from the top to bottom. One would think then that version two should be arranged so it then opposes the phase rotation, but unfortunately it would seem that a double negative may imply, in other words the opposite of an opposite is itself. This means that there should be no difference of operation of the 666 pancake system with reversed magnetic fields, essentially a north pole reacting with another north pole will achieve the same results as the version constructed oppositely with south pole interaction. HDN No difference shown with reverse wiring of 666 pancake machine Sun Sep 4, 2011 6:08 pm
The next test must become an exact duplication in reverse of the original set-up. It will involve more laborious winding changes where segmental elements of all three phases will be interchanged. This then instead of a clockwise spiral going upwards diagonally through the three series connected spiralled segments will instead be a counterclockwise spiral going upwards. In the previous test it was thought that a counterclockwise direction going downwards from the source stator line connections made in delta would accomplish that change; apparently this is not true as it is a mirror image of the original by double negative cancellation. I made false conclusions near the end of the video record of this test made today, due to the fact that the variac to 4/1 transformer step down for DC rectification to field was set at 16 volts instead of 20 volts. I use 120 uf for the DC cap filter for DC field current on the alternator, a somewhat large quantity I suppose. In any case information is gleaned in this video where I have now showed the changes involved with employing solitary phase loads vs that of adding all three phases. Interesting stator voltage changes upon addition of phasal loads are shown, (from unenergized field tests). Theorized effects due to phase rotation are also indicated. Video concludes with actual field energization. Some have voiced the opinion that the cyclic voltage appearance on stator outputs might be due to DC ripple to field, so to settle this matter a pure DC battery source to field will also need to be tested. Wiil look at the time on this video and report back about you tube loading. HDN Pioneering the Applications of Interphasal Resonances http://tech.groups.yahoo.com/group/teslafy/
