Hi, I saw that too. I installed 2.1.6-beta-4 on Ubuntu 9.10. When you open the settings, uncheck the banner and save - the banner will not be shown. Reopen the page in the gui, the option is checked again, but still will not be shown on connect. But if you change anything in the config and save it, the connect banner is back - until you switch it off and save again.
Cheers, Clemens Michael wrote: > Hello list, > > When using the Qt GUI to configure 'n:client-banner-enable:0' and > turn it off, I continue by pressing 'Save'. If I go back and look > at the configuration afterwards, then banner setting is enabled > again and set to 'n:client-banner-enable:1'. What is going on? > > A similar problem (or misunderstanding) ocurrs when I set the > 's:ident-client-type:asn1dn' to ASN.1. After saving and coming > back the entry is always set to 's:ident-client-type:fqdn'. > > I'm using the Shrew ike daemon (packaged with the Qt client) > version 2.1.4 on Ubuntu Linux 9.10. > > Does anyone know the reason for this strange behaviour? > > Thanks, > Michael > _______________________________________________ > vpn-help mailing list > [email protected] > http://lists.shrew.net/mailman/listinfo/vpn-help > _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
