Hello list, On Tues., March 31, 2010, Clemens Perz wrote: >Michael wrote: >> When using the Qt GUI to configure 'n:client-banner-enable:0' and >> turn it off, I continue by pressing 'Save'. If I go back and look >> at the configuration afterwards, then banner setting is enabled >> again and set to 'n:client-banner-enable:1'. What is going on? >> >> A similar problem (or misunderstanding) ocurrs when I set the >> 's:ident-client-type:asn1dn' to ASN.1. After saving and coming >> back the entry is always set to 's:ident-client-type:fqdn'. >> >> I'm using the Shrew ike daemon (packaged with the Qt client) >> version 2.1.4 on Ubuntu Linux 9.10. >> >> Does anyone know the reason for this strange behaviour? >> >I saw that too. I installed 2.1.6-beta-4 on Ubuntu 9.10. When you >open the settings, uncheck the banner and save - the banner will >not be shown. Reopen the page in the gui, the option is checked >again, but still will not be shown on connect. But if you change >anything in the config and save it, the connect banner is back - >until you switch it off and save again. > Okay, so after getting a few replies (some privately) I assume that this is a bug in the software. I think it is time to switch to using the command line client which I think is called ikea, and write the config files by hand.
Regards, Michael _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
