On 6/28/2010 11:03 PM, Jerry Holland wrote: > I don't expect anyone to be able to jump right in with a solution, but... > I am trying to configure the Shrew VPN client to replace the netgear > client that is being used on a Netgear FVS338 and three workers using > vista. We want to upgrade to windows 7, and my little netbook running > Win7 is the test mule. > The netgear client works perfectly with the vista, but I cheated on the > installation. Netgear configured the file for me, and emailed it to me. > When I start the Shrew client, I get this on the dialog box: > Config loaded for site 'xx.x.xx.xx" (x's provided here for modesty) > configuring client settings > attached to key daemon > peer configured > iskamp proposal configured > esp proposal configured > client configured > local id configured > pre-shared key configured > bringing up tunnel > (and after a short while...) > negotiation timout occurred > tunnel disables > detached fro key daemon > Anyone have any suggestions on how I start my troubleshooting journey on > this one? > Jerry
Log output of where the failure occurs would be helpful. Likely your phase1 parameters or your authentication settings are mismatched ... http://www.shrew.net/support/wiki/BugReportVpnWindows You will want to remove your gateway IP address before posting output to the list. -Matthew _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
