Adding to Mattew's post, to get log output,I think you have to run the Trace Utility as administrator (right click on , run as administrator) Mike
-----Original Message----- From: Matthew Grooms <[email protected]> To: Jerry Holland <[email protected]> Cc: [email protected] Sent: Tue, Jun 29, 2010 12:13 am Subject: Re: [vpn-help] trying to connect to a Netgear FVS338 On 6/28/2010 11:03 PM, Jerry Holland wrote: I don't expect anyone to be able to jump right in with a solution, but... I am trying to configure the Shrew VPN client to replace the netgear client that is being used on a Netgear FVS338 and three workers using vista. We want to upgrade to windows 7, and my little netbook running Win7 is the test mule. The netgear client works perfectly with the vista, but I cheated on the installation. Netgear configured the file for me, and emailed it to me. When I start the Shrew client, I get this on the dialog box: Config loaded for site 'xx.x.xx.xx" (x's provided here for modesty) configuring client settings attached to key daemon peer configured iskamp proposal configured esp proposal configured client configured local id configured pre-shared key configured bringing up tunnel (and after a short while...) negotiation timout occurred tunnel disables detached fro key daemon Anyone have any suggestions on how I start my troubleshooting journey on this one? Jerry Log output of where the failure occurs would be helpful. Likely your hase1 parameters or your authentication settings are mismatched ... http://www.shrew.net/support/wiki/BugReportVpnWindows You will want to remove your gateway IP address before posting output to he list. -Matthew ______________________________________________ pn-help mailing list [email protected] ttp://lists.shrew.net/mailman/listinfo/vpn-help
_______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
