Hi, You laptop is directly connected to Internet ? (no NAT). Because the NETGEAR DG834 support only the MAIN Mode... (and the VPN is buggy...)
Regards, On Mon, Mar 7, 2011 at 11:32 AM, Howard Spindel <[email protected]> wrote: > I'm trying to setup a VPN that will allow me to connect in to my home > network (with a Netgear DG834Gv4 facing the internet) from a Windows 7 > laptop. > > Can anyone provide a cookbook for setting the Netgear VPN settings and > ShrewSoft VPN client that would enable the two to connect? I've been > tearing my hair trying all sorts of combinations, but can't get anything to > work. The VPN trace on the Win 7 laptop shows three attempts to send phase1 > packets before it hits "resend limit exceeded for phase1 exchange" and > aborts. > > I am a computer programmer with 30 years experience and lots of networking > experience, but I can't figure this one out! > > Thanks, > Howard > > Netgear policy page looks like this right now: > > Remote VPN Endpoint: Dynamic IP address > Local LAN: IP address is set to my local subnet > Remote LAN: IP address is set to "Single PC - no subnet" > IKE direction: responder only (only choice allowed) > Exchange mode: Main mode (only choice allowed) > DH group: auto > Local ID type: WAN IP address > Remote ID type: FQDN > Encryption algorithm: 3DES > Authentication algorithm: auto > Using a pre-shared key for authentication > > > > _______________________________________________ > vpn-help mailing list > [email protected] > http://lists.shrew.net/mailman/listinfo/vpn-help >
_______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
