In all likelihood, the laptop would no be directly connected to the
internet. I would be at the mercy of whomever was providing a hot spot.
Is there no way to get that to work?
Hi,
You laptop is directly connected to Internet ? (no NAT). Because the
NETGEAR DG834 support only the MAIN Mode... (and the VPN is buggy...)
Regards,
On Mon, Mar 7, 2011 at 11:32 AM, Howard Spindel
<<mailto:[email protected]>[email protected]> wrote:
I'm trying to setup a VPN that will allow me to connect in to my
home network (with a Netgear DG834Gv4 facing the internet) from a
Windows 7 laptop.
Can anyone provide a cookbook for setting the Netgear VPN settings
and ShrewSoft VPN client that would enable the two to connect? I've
been tearing my hair trying all sorts of combinations, but can't get
anything to work. The VPN trace on the Win 7 laptop shows three
attempts to send phase1 packets before it hits "resend limit
exceeded for phase1 exchange" and aborts.
I am a computer programmer with 30 years experience and lots of
networking experience, but I can't figure this one out!
Thanks,
Howard
Netgear policy page looks like this right now:
Remote VPN Endpoint: Dynamic IP address
Local LAN: IP address is set to my local subnet
Remote LAN: IP address is set to "Single PC - no subnet"
IKE direction: responder only (only choice allowed)
Exchange mode: Main mode (only choice allowed)
DH group: auto
Local ID type: WAN IP address
Remote ID type: FQDN
Encryption algorithm: 3DES
Authentication algorithm: auto
Using a pre-shared key for authentication
_______________________________________________
vpn-help mailing list
<mailto:[email protected]>[email protected]
http://lists.shrew.net/mailman/listinfo/vpn-help
_______________________________________________
vpn-help mailing list
[email protected]
http://lists.shrew.net/mailman/listinfo/vpn-help
