Hello Scott, have you tried to start the Shrew Soft VPN services only on demand and shutting them down after you disconnected from the VPN? This solves a lot of connectivity issues in the newer versions of the software.
To start the VPN services only on demand, you will at first have to shut them down (may require administrative privileges): net stop "ShrewSoft IKE Daemon" net stop "ShrewSoft IPSEC Daemon" Afterwards, set the start type for these services to "Manually" by importing the following registry entries: Windows Registry Editor Version 5.00 [HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\iked] "Start"=dword:00000003 [HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\ipsecd] "Start"=dword:00000003 Now, the Shrew Soft VPN services are not started automatically upon system boot any longer. You can now start them manually so that they run only if needed. To start the VPN services: net start "ShrewSoft IKE Daemon" net start "ShrewSoft IPSEC Daemon" Using a script, you can then also bring up the VPN connection dialog: %ProgramFiles%\ShrewSoft\VPN Client\ipsecc.exe -r NameOfYourConnection -u YourUserName The disconnect is then also done by the following commands: taskkill /T /F /IM "ipsecc.exe" net stop "ShrewSoft IKE Daemon" net stop "ShrewSoft IPSEC Daemon" This works for me without problems for more than a year now. Kind regards, Gerd 2013/10/22 Scott Woodbridge <[email protected]> > *Problem*: > After initial installation and configuration of the VPN tunnel, Shrew Soft > successfully connects and passes traffic to/from network devices. The > tunnel connects rapidly. > > After closing/disconnecting the tunnel, subsequent connections succeed, > but slowly. After the tunnel is enabled, traffic will no longer pass. > Quitting the Shrew Soft client, rebooting the PC, have no effect. > > > *Workaround:* > The only workaround discovered so far is to perform the following steps in > sequence: > 1) Open Network and Sharing Center in the Control panel. > 2) Right click on the LAN connection, select 'properties', deselect the > "Shrew Soft Lightweight Filter", click 'ok' to save. > 3) Right click on the LAN Connection, select 'disable'. > 4) Right click on the LAN Connection, select 'enable' > 5) Right click on the LAN connection, select 'properties', select the > "Shrew Soft Lightweight Filter", click 'ok' to save. > > > *Environment*: > Shrew Soft VPN Client (Std) 2.2.2 > Windows 7 SP1 > Dell OptiPlex 3010 > Realtek PCIe GBE (Driver 5.810.1218.2012) > Cisco SA500 > > > Any suggestions would be appreciated. > > > > _______________________________________________ > vpn-help mailing list > [email protected] > https://lists.shrew.net/mailman/listinfo/vpn-help > >
_______________________________________________ vpn-help mailing list [email protected] https://lists.shrew.net/mailman/listinfo/vpn-help
