It looks like it can't find or open the initramfs. In the initrd creation step try this instead.
find . | cpio --quiet --dereference -o -H newc | gzip -9 > ../tmpiso/boot/initrd.img Cheers, Robert. Max wrote: > Well I followed your directions step by step and didn't have any > problems until attempting to boot the CD. Check out the attached > screen shot.. > What do you recommend checking out? > > > > On Nov 27, 2007 5:39 PM, Max <[EMAIL PROTECTED]> wrote: >> That was more less what i was going to do. You saved me a good deal of >> work trying to figure out the right way to recreate the ISO. If this >> works out, I owe you a pint! :D >> >> >> On Nov 27, 2007 5:07 PM, Robert Bays <[EMAIL PROTECTED]> wrote: >>> Max, >>> >>> To avoid building from scratch you could just edit the initrd. Try >>> something like the following... >>> >>> 1. mount the iso to a loop device and copy the contents to a tmpdir >>> mount -o loop ./livecd-vc3.iso ./dir >>> cp -R ./dir/* ./tmpiso/ >>> umount ./dir >>> 2. extract the initrd.img >>> mkdir tmpinitrd >>> cd tmpinitrd >>> gzip -cd ../tmpiso/boot/initrd.img.img | cpio -imd --quiet >>> 3. remove the module >>> rm ./lib/modules/2.6.20/kernel/drivers/scsi/sym53c8xx_2/sym53c8xx.ko >>> 4. zip up the initrd and copy it into the temporary iso dir >>> chmod -R 755 ../tmpiso >>> rm ../tmpiso/boot/initrd.img >>> find . | cpio --quiet -c -o | gzip -9 -n >> ../tmpiso/boot/initrd.img >>> 5. create the iso >>> cd ../tmpiso >>> mkisofs -J -r -o ../livecd.iso -b boot/isolinux/isolinux.bin -c >>> boot/isolinux/boot.cat -no-emul-boot -boot-load-size 4 -boot-info-table >>> /home/rbays/tmpiso/ >>> >>> Should work... >>> >>> Cheers, >>> Robert. >>> >>> >>> Max wrote: >>>> No I have not had any time to fool with it these past few days... >>>> but from what I can tell the sym53c8xx module is loaded before the needed >>>> cpqarray module and thats what is causing the failure. I have tried >>>> unloading the modules and reloading cpqarray but don't seem to have >>>> any luck. My guess is the SCSI controller needs to be reset or what >>>> have you. >>>> I have not had any luck disabling the sym53c8xx module from the boot >>>> loader so I think the next step is to build a live CD from scratch. >>>> I've never built a live CD so its going to be a learning thing for me >>>> for sure. Maybe you will have better luck... Let me know if you find >>>> anything :) >>>> >>>> On Nov 26, 2007 11:46 PM, Cory B. Goleman <[EMAIL PROTECTED]> wrote: >>>>> >>>>> >>>>> I'm having the same problem, trying to install Vyatta 3.0 to a DL 360 G1 >>>>> with a RAID 1 configuration, have you made any progress on this? >>>>> >>>>> >>>>> >>>>> Regards >>>>> >>>>> Cory- >>>>> >>>>> >>>> _______________________________________________ >>>> Vyatta-users mailing list >>>> Vyatta-users@mailman.vyatta.com >>>> http://mailman.vyatta.com/mailman/listinfo/vyatta-users >> >> ------------------------------------------------------------------------ >> _______________________________________________ Vyatta-users mailing list Vyatta-users@mailman.vyatta.com http://mailman.vyatta.com/mailman/listinfo/vyatta-users