After a brief hiatus and LOTS of work to build from scratch, I may say that Gary might be correct. That is, swapping SD card from RPi3 to RPi4 may not work.
Then went backwards and built RPi4 from scratch, installed all the latest regarding Raspian, WeeWX release (4.0.0b14) and Belchertown (1.1b9). Sure, went through usual difficulties in the way, but now ALL working accordingly. To note, my weewx site also have some extras and mods, but all working fine. In summary: - RPi4 - Raspian vs-10 (buster) - WeeWX 4.0.0b14 - WeatherFlow - Python 3.7.3 - PyEphem 3.7.7.1 - Belchertown skin 1.1b9 - MQTT - InfluxDB - Grafana http://appnea.net/ Best, Xant On Friday, December 6, 2019 at 2:06:56 AM UTC-5, gjr80 wrote: > > Don't see this as a WeeWX or a skin issue, rather one of hardware/OS > compatibility. I am not surprised that a SD card with Linux setup for a RPi > 3B+ does not work without change on a RPi 4. That's a bit like taking the > hard disk out of my PC and plugging it into a different PC and expecting > everything to work. Different hardware/drivers/libraries/config etc. > Unfortunately I think you will need to install Linux on another card, > install WeeWX, copy your WeeWX config/skins etc and any other supporting > packages/conf (eg MQTT). > > Gary > > On Friday, 6 December 2019 15:39:39 UTC+10, Armando Esteves wrote: >> >> Upon going to upgrade WeeWX, took the leap to upgrade all: ie, 1-WeeWX, >> 2-Bskin and 3-hardware (Rpi). Sure indeed, opened 3 Pandora boxes... but >> before mixing too much, lets start with the "simple" and awkward behaviour >> (in recent post, I mentioned upgrading WeeWX to 4 and Bskin to 1.1b8, which >> lead to other troubles, but lets disregard this for now, as it is another >> SD card). >> >> >> Original setting: >> >> 1. WeeWX 3.9.2 >> 2. Bskin 1.1b7 (with MQTT) >> 3. Rpi 3B+ >> >> >> The awkward thing (and purpose note of this post) is that there is a >> hardware related Rpi conflict issue. That is: >> >> A) SD card with original setting above on Rpi 3B+ works well and as >> expected >> >> >> B) SAME SD card with original setting above on Rpi 4B is NOT updating >> data (charts) >> >> >> >> That is, if plug SD card into Rpi 3B+ works; if plug SD card into Rpi 4B >> it doesn't (while MQTT connected and ticking all time). >> >> My WX website (temp Domain): >> >> http://www.appnea.net >> >> >> Per this posting time, SD into Rpi 4B. You may notice no update since >> Dec5 11:55pm (can switch back to Rpi 3B+ per request). >> >> Not sure if WeeWX or Bskin issue. >> >> Note: PWS is WeatherFlow. >> >> X >> > -- You received this message because you are subscribed to the Google Groups "weewx-development" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-development/90dcf6ed-9f3f-4b0a-a555-079beaf9a378%40googlegroups.com.
