Hello, I have an RPi properly configured to allow the /dev/ttyAMA0 serial port to work. To verify this, I've jumpered pins 8 & 10 on the RPi GPIO connector, so data is looped back as I type. When connecting the VP2 and running 'sudo wee_device' I get:"weewx.WakeupError: Unable to wake up Vantage console", as the last line. The VP2 firmware is version 3.15, which I think falls into the little trap created by the folks at Davis Instruments, where they don't want you using their serial port to extract data, unless you purchase one of their expensive add-ons (data logger).
Could I be correct, in that my suspicion is a firmware problem? If so, the only thing I can see to do is use one of their data loggers to pull the data out and then convert it from RS232 levels (their data logger output) back to 3.3 volt levels suitable for the RPi. Does anyone else have other ideas? Am I on the right track? Thanks! Michael K6MLE -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
