I will try this one for now! I hope weewx will use it later to calculate dew point and heat index with this value.
[StdCalibrate] [[Corrections]] outHumidity = extraHumid1 if extraHumid1 is not None else None torek, 7. november 2023 ob 12:36:26 UTC+1 je oseba [email protected] napisala: > Thanks, I forgot about that! Then I would definitely prefer getting an > Ecowitt Gateway + outdoor sensor over the replacement part. > > gjr80 schrieb am Montag, 6. November 2023 um 21:08:54 UTC+1: > >> Not necessary, if the Ecowitt gateway driver can be used it can be run as >> a data service to augment an existing driver. >> >> Gary >> >> On Tuesday, 7 November 2023 at 06:03:39 UTC+10 [email protected] wrote: >> >>> With the ecowitt gateway you need a second weewxd running, as a >>> downside. But you can build a whole new station, step by step, around that >>> gateway (which is probably way to go, sooner or later). >>> >>> vince schrieb am Montag, 6. November 2023 um 20:41:08 UTC+1: >>> >>>> Another option is an ecowitt gateway and their outside T+H sensor, >>>> which integrates well into weewx. >>>> >>>> On Monday, November 6, 2023 at 11:19:23 AM UTC-8 [email protected] >>>> wrote: >>>> >>>>> Do not use a BME280 as an outdoor Sensor, it is not suited for this >>>>> purpose. The operating range is only valid in non-condensing >>>>> environments. >>>>> In condensing environments, especially below freezing point, these >>>>> sensors >>>>> are proven unusable. Go for a SHT3x or SHT4x. >>>>> >>>>> Mark Fraser schrieb am Montag, 6. November 2023 um 18:32:59 UTC+1: >>>>> >>>>>> On 06/11/2023 08:18, [email protected] wrote: >>>>>> > Hello i have ws2300 station and my humidity sensor probably died. >>>>>> It >>>>>> > only shows values from 70 to 80% .I cannot get replacement part >>>>>> anywhere >>>>>> > because it is not in production anymore and I cannot buy whole new >>>>>> > station because it will be complicated to get all things up running >>>>>> again. >>>>>> > >>>>>> > I was thinking of getting external humidity sensor and hook it to >>>>>> > arduino board and then read humidity values remotely via crontabs >>>>>> in a >>>>>> > txt file. Is is somehow possible to "trick" weewx to read this >>>>>> value >>>>>> > instead of getting it from station because I am using weewx to >>>>>> calculate >>>>>> > heat index and dew point. >>>>>> Could you use something like BME280WX from here? >>>>>> https://gitlab.com/wjcarpenter/bme280wx >>>>>> >>>>> -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/2e465635-de06-439e-9d72-f8c2e0439aa0n%40googlegroups.com.
