Did you remember to set the router up to send SNMP Trap messages to your WUG system?
------------------------------------------------------------ Bryan Harrell, SPII Network Transport & Administration - Tallahassee Fla. Dept of Revenue (850)-921-0700 S/C 291-0700 ------------------------------------------------------------ >>> [EMAIL PROTECTED] 12/11/2003 10:33:17 AM >>> Hi I've setup an snmp trap event on a cisco 3550 to watch for any interfaces to go down and alert if they do. So I've added the snmp event "linkdown" to the device and I'm trying to use snmpnotify to generate a test message and I've got snmpnotify to send a message to whatsup and the "ifoperstatus" trap shows up under the device yet there is no indication of the actual status. I see under the snmpnotify syntax that I have to specify the variable type and value (type would be integer and value would be 2 to specify a down interface) and I cant seem to get the syntax right to get the status to show up. Please help. Jason D. Humes Applied Computer Solutions Inc. 3020 St. Etienne Blvd. Windsor, Ontario Phone: (519) 944-4300 x211 Fax : (519) 944-4247 Email : [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> ********************************************************************** Confidentiality Notice: The information contained in this e-mail and any attachments may be legally privileged and confidential. If you are not an intended recipient, you are hereby notified that any dissemination, distribution or copying of this e-mail and any attachments is strictly prohibited. If you received this e-mail in error, please notify the sender and permanently delete the e-mail and any attachments immediately. You should not retain, copy or use this e-mail or any attachment for any purpose, nor disclose all or any part of the contents to any other person. Thank you. Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
