You'll be pleased to know that the answer is "Yes". You will be able to set up each monitor with it's own poll frequency (ie, ping every 60 seconds and check the HTTP every 300) and alerts (or "actions", to give them their WhatsUp Pro name) will be tied to the monitor. Thus, email one person when the device cannot be pinged and email someone different when the webserver on the device does not respond.
Mark Symons Ipswitch, Inc Augusta GA -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Wittke, Marc Sent: Wednesday, July 28, 2004 10:08 To: [EMAIL PROTECTED] Subject: AW: [WhatsUp Forum] Alerts to different destinations? "The way to do this in v8.0x..." <-- does this mean that v9 brings a better solution? ;) -----Urspr�ngliche Nachricht----- Von: Mark Symons [mailto:[EMAIL PROTECTED] Gesendet: Mittwoch, 28. Juli 2004 15:54 An: [EMAIL PROTECTED] Betreff: RE: [WhatsUp Forum] Alerts to different destinations? Finbom wrote: > My wish: > To separate the service alerts so they are sent to > another destination. > So that when the server goes down, everyone is alerted. > But when a monitored service fails only a few are alerted. The way to do this in v8.0x is to create a coy of the device on your map. On one copy you just monitor the device itself and configure the alert that goes to everyone. On the other copy you monitor the service and configure the alert that only goes to a few people. Mark Symons Ipswitch, Inc Augusta GA -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Finbom Magnus Sent: Wednesday, July 28, 2004 03:59 To: '[EMAIL PROTECTED]' Subject: [WhatsUp Forum] Alerts to different destinations? Hi! Is this possible? Scenario: I have my WUG to monitor up/down-state on a server. WUG is also monitoring some services. And when the server goes down or a service fails an alert is sent. My wish: To separate the service alerts so they are sent to another destination. So that when the server goes down, everyone is alerted. But when a monitored service fails only a few are alerted. I know how to setup filter out events and choose where the alert will be sent. But when it comes to "monitor and services" all alarms are sent together. Can it be done? Hope you understand. Best regards Magnus Finbom IT-Engineer(Microsoft MCP, MCP+I, MCSE-NT4) Lansforsakringar Skaraborg Bank and Insurance Radhusgatan 8 54129 Skovde Sweden phone 0500 77 70 65, gsm 0708 71 70 60, fax 0500 77 70 30 [EMAIL PROTECTED] http://www.lansforsakringar.se/skaraborg Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/ Please visit http://www.ipswitch.com/support/mailing-lists.html to be removed from this list. An Archive of this list is available at: http://www.mail-archive.com/whatsup_forum%40list.ipswitch.com/
