From: "Wayne Johnson"
Thank you for inquiring.
Thanks for the answer. (I had asked before, recently, but no
one understood the question, so I got no answers.)
Problem is, this next reply is a "yes,-but"...
I have the settings you said, so there must be more to it...
I am usually pretty good at figuring this out, but to do that
I'd have to read everyone headers, see that E-mail program
they were using and the settings they used... (Sounds like
too much work for a questionable answer...) Plus, then I'd
have to experiment... (Send messages and wait for replies, etc...)
A couple people (so far) said I was using:
"Content-transfer-encoding: quoted-printable"
which "everyone" can see in my headers...
I guess that is what I needed to change, but to what?
(I don't use OutLook because it makes it too hard to get to
the headers, and several other more important reasons...)
FWIW: I closed this message and changed my setting to:
mime: encoding none.
Lets see if that helps... (Rich, you game on your OE client?)
BTW: I "can" mix in answers but then "that" often screws up
the spellchecking (not always -- gotta love it!...)
Then I have to "do" a "select all" and run a manual spellcheck
OR look like an idiot that can't spell...
Rick Glazier
--
----------------------------------------
To Change your email Address for this list, send the following message:
CHANGE WIN-HOME your_old_address your_new_address
to: [EMAIL PROTECTED]
Note carefully that both old and new addresses are required.
