Hi Murali, Close Wireshark, run your command prompt as an administrator and type in "net start npf". Open Wireshark again and see if you get the same message.
- Jay On Mon, Sep 24, 2012 at 11:30 AM, Karthik Raguraman, Murali < [email protected]> wrote: > Hi Team,**** > > ** ** > > I have installed Wire shark 1.6.5 and Microsoft Visual C++ 2005 SP1 > Redistributable x86 as a prerequisite and installed WinPCAP 4.1.2 , but I > get the below errors :**** > > **** > > **** > > **** > > And **** > > **** > > **** > > **** > > Please Assist me on this.**** > > **** > > Thanks in Advance**** > > **** > > Warm Regards **** > > **** > > *Murali Karthik R* **** > > > _______________________________________________ > Winpcap-users mailing list > [email protected] > https://www.winpcap.org/mailman/listinfo/winpcap-users > >
<<ATT00002.png>>
<<ATT00001.png>>
_______________________________________________ Winpcap-users mailing list [email protected] https://www.winpcap.org/mailman/listinfo/winpcap-users
