On the AP side (producion system for year), it shows this test rb133 registered with rx 1M and tx to it of 6M. Its like the rb133 system refuses to transmit at any rate above 1M?? Still, no ping between the two.
On 7/1/08, rabbtux rabbtux <[EMAIL PROTECTED]> wrote: > no WDS and no Bridging involved. Using MT ping utility from either end. > > I have swapped out CM9 radios and gone to a 'clean' rb133 with the > same ros2.9.50 as the AP. > > I moved the client closer and noticed one ODD thing. With -72db on > both sides or even with -62db, the Registered rate is always 1M? yes, > this is 802.11a, yes the radios are set to 5.8G. The 'default' rates > are selected for radios on each end. Any ideas?? > > > On 7/1/08, Mac Dearman <[EMAIL PROTECTED]> wrote: > > 1. Kill all encryption on both ends, get them to pass traffic and then > > proceed with enabling encryption. > > 2. be sure you have WDS in the bridge or have both sides set to dynamic & > > bridge1 (or whatever it is) > > 3. Be sure of your gateway on both sides (this is generally the easiest to > > jack up) > > > > Mac > > > > > > > > > > > > > -----Original Message----- > > > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On > > > Behalf Of rabbtux rabbtux > > > Sent: Tuesday, July 01, 2008 7:50 PM > > > To: WISPA General List > > > Subject: Re: [WISPA] help! replacement MT based 5.8G system connects, > > > but no ping! > > > > > > IP address on singel CM9 radio interface. Just Swapped out the pre > > > configured RB333 system with a clean RB133 and freshly configured to > > > the other AP. Still, it associates with encryption key, but no ping! > > > (hope I still have hair by morning :-) > > > > > > On 7/1/08, Mark Nash <[EMAIL PROTECTED]> wrote: > > > > Are the IP addresses on a bridge or an Interface? > > > > > > > > Mark Nash > > > > UnwiredWest > > > > 78 Centennial Loop > > > > Suite E > > > > Eugene, OR 97401 > > > > 541-998-5555 > > > > 541-998-5599 fax > > > > http://www.unwiredwest.com > > > > > > > > ----- Original Message ----- > > > > From: "rabbtux rabbtux" <[EMAIL PROTECTED]> > > > > To: "WISPA General List" <[email protected]> > > > > Sent: Tuesday, July 01, 2008 5:18 PM > > > > Subject: [WISPA] help! replacement MT based 5.8G system connects,but > > > no > > > > ping! > > > > > > > > > > > > > All, > > > > > > > > > > I'm at wits end as my network is crippled and I'm having problems > > > > > getting the replacement system to talk. Both systems have the > > > correct > > > > > security key, as they will not register to each other correctly > > > > > without it. The new system is ros3.9 and it is PTP with another > > > > > ros2.9.50 system. These two systems connect with 65dbm signal > > > > > strength but I can't ping from either end. I, of course > > > double/triple > > > > > checked interface IPs and masks. I have used MT for about a year > > > and > > > > > a half, without issue, however, I'm probably missing something > > > here as > > > > > I work with looming customer calls about when will the replacement > > > > > system be up! > > > > > > > > > > Anyway, It would be great to speak to someone with more MT > > > experience > > > > > than myself on this one! Please hit me off list for details. > > > > > > > > > > Thank you kindly, > > > > > Marshall Craw > > > > > Rabbit Meadows Tech. > > > > > > > > > > > > > > > > > > > ------------------------------------------------------------------- > > > ------------- > > > > > WISPA Wants You! Join today! > > > > > http://signup.wispa.org/ > > > > > ------------------------------------------------------------------ > > > -------------- > > > > > > > > > > WISPA Wireless List: [email protected] > > > > > > > > > > Subscribe/Unsubscribe: > > > > > http://lists.wispa.org/mailman/listinfo/wireless > > > > > > > > > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > > > > > > > > > > > > > > > > > > > > > > > > > -------------------------------------------------------------------- > > > ------------ > > > > WISPA Wants You! Join today! > > > > http://signup.wispa.org/ > > > > -------------------------------------------------------------------- > > > ------------ > > > > > > > > WISPA Wireless List: [email protected] > > > > > > > > Subscribe/Unsubscribe: > > > > http://lists.wispa.org/mailman/listinfo/wireless > > > > > > > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > > > > > > > > > > > ----------------------------------------------------------------------- > > > > > --------- > > > WISPA Wants You! Join today! > > > http://signup.wispa.org/ > > > ----------------------------------------------------------------------- > > > --------- > > > > > > WISPA Wireless List: [email protected] > > > > > > Subscribe/Unsubscribe: > > > http://lists.wispa.org/mailman/listinfo/wireless > > > > > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > No virus found in this incoming message. > > > Checked by AVG. > > > Version: 8.0.101 / Virus Database: 270.4.3/1528 - Release Date: > > > 7/1/2008 7:26 AM > > > > > > > > > > > -------------------------------------------------------------------------------- > > WISPA Wants You! Join today! > > http://signup.wispa.org/ > > > -------------------------------------------------------------------------------- > > > > WISPA Wireless List: [email protected] > > > > Subscribe/Unsubscribe: > > http://lists.wispa.org/mailman/listinfo/wireless > > > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
