Same here. For me, I am going to go slowly with a small project. Actually, I just did a small project with UBNT and it went well. So, the next project will be a bit bigger and so on. -RickG
On Sat, Dec 19, 2009 at 9:35 AM, Mike <[email protected]> wrote: > I was almost ready to pull the trigger on some Ubiquiti equipment for > a new project. The scent of low price is alluring. Then I start > reading about connectors pulling out, connectors not soldered on > properly, and the wrong boot code on boards. > > Is it too early? Should I wait a bit before I dive in? Has the > haste to get product into the distribution stream compromised quality > control? Is the low price just too good to be true? I'd be > interested in some constructive thoughts and analysis. > > Thanks mg > > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
