If the link is good I would enable nstreme. Pay attention to your over
the air rates. If they tend to ³flap² I would lock out the higher rates.
You will get a better CCQ out of the link by doing that. If it were me I
would enable WDS unless you are using the ³CPE² end as a station in router
mode. Our typical setup is WDS bridges with routers at the bottom.
I am sure there is some more but that is what is falling out of my head
at the moment.
Justin
--
Justin Wilson <[email protected]>
http://www.mtin.net/blog
Wisp Consulting Tower Climbing Network Support
From: Akinlolu Ajayi-Obe <[email protected]>
Reply-To: <[email protected]>, WISPA General List
<[email protected]>
Date: Wed, 28 Apr 2010 06:23:28 +0000
To: <[email protected]>
Subject: [WISPA] MT PtP
I want to setup an MT point to point using two MT 411 boards, 350mw cards
and a 23db rootena. Distance is 7km. Is there anything I need to tweak or
watch out for? New to MT. I have setup a basic link and tested in the
office.
Thanks
Akin
Sent from my BlackBerry® smartphone
----------------------------------------------------------------------------
----
WISPA Wants You! Join today!
http://signup.wispa.org/
----------------------------------------------------------------------------
----
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--------------------------------------------------------------------------------
WISPA Wants You! Join today!
http://signup.wispa.org/
--------------------------------------------------------------------------------
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
