This is testing with pc on either end of the radio, plugged in 100fdx ethernet with iperf. Didn't check ota built-in speedtest. No other traffic on radio.
Sent from my iPad On Jul 25, 2011, at 4:28 PM, "Faisal Imtiaz" <[email protected]> wrote: > How are you testing ? > > via Radios or via the Mikrotik's behind the radios ? > > What is the Recieve test by itself showing and what is the Transmit test by > it'self showing. > > also double check to make sure that the MT's and the Radios have ethernet > handshake correct. > You may have to ssh into the radio's and issue the following commands to > make sure that ethernet interfaces are not dropping any packets. > ... ifconfig to show status > or ethtool eth0 to show handshake... > > > As a rule...... you should expect to see about 50% to 75% of the air-rate in > each direction.(not running duplex test). > Faisal Imtiaz > Snappy Internet & Telecom > > On 7/25/2011 5:06 PM, Patrick D. Nix, Jr wrote: >> >> Ok, so WDS fixed the latency. At 20mhz channel and 100%ccq what should our >> actual throughput be. We are only seeing 20mbps max. >> >> Sent from my iPad >> >> On Jul 25, 2011, at 1:40 PM, "Faisal Imtiaz" <[email protected]> wrote: >> >>> Yes, .... in the UBIQUITY World, if you want a transparent bridge... use >>> WDS (so ... wds always !). >>> and YES, turn on AIRMAX... >>> (Airmax is proprietary to Ubiquity, so two UBNT radios are much happier >>> with Airmax on, plus with Airmax is not 'compatible' with standards >>> 802.11a/b/g/n so other radios will see the signal but will not attempts to >>> connect. >>> >>> How wide are the channels, and is there any interference on them ? >>> >>> Regards. >>> >>> Faisal Imtiaz >>> Snappy Internet & Telecom >>> 7266 SW 48 Street >>> Miami, Fl 33155 >>> Tel: 305 663 5518 x 232 >>> Helpdesk: 305 663 5518 option 2 Email: [email protected] >>> >>> On 7/25/2011 1:33 PM, Patrick D. Nix, Jr wrote: >>>> >>>> It is routed, using miktrotik routers. Do I use WDS with airmax? I don't >>>> think it is a loop because the other bridges are basically doing the same >>>> thing but not seeing the same problem. They are Trango link 45's >>>> >>>> Sent from my iPad >>>> >>>> On Jul 25, 2011, at 12:04 PM, "Faisal Imtiaz" <[email protected]> wrote: >>>> >>>>> Sounds like you are creating a loop somewhere... >>>>> >>>>> Is this a routed network ? or a bridge Network. >>>>> (Make sure that you have WDS on for fully transparent bridge) >>>>> and also make sure you turn off Enable Discovery in the first tab >>>>> (picture of airmax logo)... (equivalent CDP in the cisco world). >>>>> >>>>> Also keep in mind that if you are using Cisco Switches in your network.. >>>>> and it is a bridge network...... Cisco's by default have STP ON .... not >>>>> OFF as one would expect. >>>>> >>>>> Regards >>>>> Faisal Imtiaz >>>>> Snappy Internet & Telecom >>>>> >>>>> On 7/25/2011 12:40 PM, Greg Ihnen wrote: >>>>>> >>>>>> Isn't -53 a little too hot? >>>>>> >>>>>> Are you using WDS? I don't know if AirMax has changed this but I know >>>>>> one used to need to run with WDS on for a purely transparent bridge. >>>>>> >>>>>> Greg >>>>>> >>>>>> On Jul 25, 2011, at 12:07 PM, Patrick D. Nix, Jr wrote: >>>>>> >>>>>>> We are working on deploying a pair of M5 dishes on our network bridging >>>>>>> point a and point b. When we plug in the network to the dishes, the >>>>>>> ping times climb to 1200+ms on side b of the bridge, and equipment >>>>>>> local to the side b of the bridge, and time out after two or more hops, >>>>>>> essentially bringing the whole network down. We can ping point to >>>>>>> point with no traffic at 2ms. We are replacing a pair of existing >>>>>>> bridges from another manuf. and not seeing this issue over these. >>>>>>> Signal is -53dbm on both sides. -85 noise floor. Any ideas? >>>>>>> >>>>>>> Patrick Nix, Jr., >>>>>>> Computer Network Solutions >>>>>>> CSWEB.NET Internet Services >>>>>>> IT Manager >>>>>>> http://www.cnetworksolutions.com >>>>>>> http://www.csweb.net >>>>>>> (918) 235-0414 >>>>>>> >>>>>>> Attention: This e-mail and any attachments may contain confidential and >>>>>>> privileged information. If you are not the intended recipient, please >>>>>>> notify the sender immediately by return e-mail, delete this e-mail and >>>>>>> destroy any copies. Any dissemination or use of this information by a >>>>>>> person other than the intended recipient is unauthorized and may be >>>>>>> illegal. >>>>>>> >>>>>>> >>>>>>> >>>>>>> -------------------------------------------------------------------------------- >>>>>>> WISPA Wants You! Join today! >>>>>>> http://signup.wispa.org/ >>>>>>> -------------------------------------------------------------------------------- >>>>>>> >>>>>>> WISPA Wireless List: [email protected] >>>>>>> >>>>>>> Subscribe/Unsubscribe: >>>>>>> http://lists.wispa.org/mailman/listinfo/wireless >>>>>>> >>>>>>> Archives: http://lists.wispa.org/pipermail/wireless/ >>>>>> >>>>>> >>>>>> >>>>>> -------------------------------------------------------------------------------- >>>>>> WISPA Wants You! Join today! >>>>>> http://signup.wispa.org/ >>>>>> -------------------------------------------------------------------------------- >>>>>> >>>>>> WISPA Wireless List: [email protected] >>>>>> >>>>>> Subscribe/Unsubscribe: >>>>>> http://lists.wispa.org/mailman/listinfo/wireless >>>>>> >>>>>> Archives: http://lists.wispa.org/pipermail/wireless/ >>>>> >>>> >>>>> >>>>> >>>>> -------------------------------------------------------------------------------- >>>>> WISPA Wants You! Join today! >>>>> http://signup.wispa.org/ >>>>> -------------------------------------------------------------------------------- >>>>> >>>>> WISPA Wireless List: [email protected] >>>>> >>>>> Subscribe/Unsubscribe: >>>>> http://lists.wispa.org/mailman/listinfo/wireless >>>>> >>>>> Archives: http://lists.wispa.org/pipermail/wireless/ >>>> >>>> >>>> -------------------------------------------------------------------------------- >>>> WISPA Wants You! Join today! >>>> http://signup.wispa.org/ >>>> -------------------------------------------------------------------------------- >>>> >>>> WISPA Wireless List: [email protected] >>>> >>>> Subscribe/Unsubscribe: >>>> http://lists.wispa.org/mailman/listinfo/wireless >>>> >>>> Archives: http://lists.wispa.org/pipermail/wireless/ >>> >> >>> >>> >>> -------------------------------------------------------------------------------- >>> WISPA Wants You! Join today! >>> http://signup.wispa.org/ >>> -------------------------------------------------------------------------------- >>> >>> WISPA Wireless List: [email protected] >>> >>> Subscribe/Unsubscribe: >>> http://lists.wispa.org/mailman/listinfo/wireless >>> >>> Archives: http://lists.wispa.org/pipermail/wireless/ >> >> >> >> -------------------------------------------------------------------------------- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> -------------------------------------------------------------------------------- >> >> WISPA Wireless List: [email protected] >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/
-------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
