Presently doing something like this may be a challenge. Theoretically you my be able to get way with it ... if.... You GPS Sync the radios. Use the one channel on each of the radios (i.e./ run them half-duplex) and depending on your distance, get more than 2 m of separation...
Doing something like this could be easier if and when UBNT comes out with firmware that can allow smaller channel size. If you have to do something like this TODAY.. you might consider speaking with Trango about their new 24GHz radios. They will do 1024QAM, and as such more efficient with spectrum, and can have smaller channel sizes. Of-course, channel size will affect throughput.. and the Trango Radios are going to be a bit more expensive. Faisal Imtiaz Snappy Internet & Telecom 7266 SW 48 Street Miami, Fl 33155 Tel: 305 663 5518 x 232 Helpdesk: 305 663 5518 option 2 Email: [email protected] On 2/4/2013 8:48 AM, Paolo Di Francesco wrote: > Hi All > > I was wondering what is your experience on Airfiber. In particular my > question is if the following scenario could work or not work in your > opinion/experience > > On tower at LocationA there are two Airfiber pointing at the same > direction LocationB and LocationC, more or less. > On the tower at LocationA, the two airfibers are mounted at let's say > 1-2 meters distance (horizontal and vertical) and 10 degrees of > difference in the 2 directions LocationB and LocationC. > LocationB and LocationC are two other towers both pointing at LocationA. > > I am wondering if at 24Ghz I could see some interference or not , in > this situaitons > > Thank you in advance > _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless
