Hello Paul, Many thanks for your swift response, and apologies for the delay in getting back to you.
On 2017-03-14, at 18:53 , Paul Williamson <[email protected]> wrote: > [...] > I was the last one to contribute to the GSE dissector implementation in > epan/dissectors/packet-dvb-s2-bb.c. > > My involvement is through an amateur radio project (Phase 4 Ground) that is > planning to use DVB-S2 for a ham radio (non-broadcast) satellite downlink. As > such, I'm not very connected into the industry standards process, so I was > unaware of parts 2 and 3 of TS102606. I'll study them now, thanks for the > pointer. Glad you found the hint useful. ;-) As I'm the editor of these docs, please don't hesitate to drop me any questions. I'm happy to assist wherever I can. > The current dissector does not handle GSE fragmentation reassembly. Adding > that is on my to-do list, but not at the top of the list. I'm guessing you > may want to have reassembly before you add more protocol level support. You > and I should coordinate to avoid duplication of effort on this. > > This work on the GSE dissector is all I've done with Wireshark, so I'm a > beginner here, too. I'm not sure what other hints to offer you. I'd be happy > to coordinate with you off-list and assist you however I can. > [...] Adding the reassembly seems like a good starting point. Happy to look into this. I've briefly looked at packet-dvb-s2-bb.c ,and it seems it does BBFrame ans well as some GSE handling. Before adding GSE reassembly, I think I might try to factor the GSE stuff out into a new packet-dvb-gse.c. Two reasons: an S2 BBFrame may contain MPEG2-TS or GSE, and GSE may be transported over DVB-T2 and DVB-C2 as well. I doesn't seem dissecting MPEG2-TS in S2 BBFrames is supported today? Many thanks and looking forward to your thoughts, --alexander ___________________________________________________________________________ Sent via: Wireshark-dev mailing list <[email protected]> Archives: https://www.wireshark.org/lists/wireshark-dev Unsubscribe: https://www.wireshark.org/mailman/options/wireshark-dev mailto:[email protected]?subject=unsubscribe
