Hi Erik,
Thanks for your suggestions. By copy of this reply, I'll bring them to
the attention of the rest of the WSJT development group. We'll put them
on out "to be considered" list of enhancements.
-- 73, Joe, K1JT
ON4PB wrote:
Dear Joe,
what do you think about the following suggestions ?
1. When a pile up condition builds up, I would like to set my tx frequency
slighty away from the dx station without changing the rx frequency. I can
do that with the tx spinner control, but have not found a way to do that in
the waterfall. When clicking (left or right) on the frequency
scale/waterfall, the rx frequency (the green bar) is changed. Would it be
possible to reserve the left click for a rx change and the right click for
a tx change, or am I ignoring something ?
And these are very cosmetic :
2. Another thing I do often is copy an entire band activity / tx frequency
line into the comments of my hrd logbook. For that, I need to swipe the
line with the left mouse button down, and the right click. Would it be
possible to do this with a single right click on the selected line (similar
to JT65HF) ?
3. The Tx=Rx and Rx=Tx buttons work perfectly, however reading the label
for programmers is confusing because it goes against the assignment
instruction. What if we replaced = with → ?
I prefer the → unicode character as opposed to>, which could be
interpreted as greater than.
Thanks for considering, and a big thank you for bringing all that to the
community,
Erik,
[email protected]
_______________________________________________
Wsjt-devel mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/wsjt-devel
