I am not sure if this problem has been mentioned before, but here goes.....

  I (and others), have had an issue with the templates in WSJT 10.0 for 
some time now. Any templates which may be modified by the user, are 
reset to the default templates when changing from one mode to another 
and then back again.  I am currently using r5490, however this issue has 
been evident over many revisions.

Case in point - I use WSJT 10.0 mainly for meteor scatter (FSK441), 70cm 
EME (JT65b) and occasionally 2meter and 70cm Terrestrial( JT65b2). In VK 
and ZL we use a different template for FSK441 compared with North 
America and Europe. Both callsigns are always sent and the report 
attached to the respondents callsign with a"/". That way, when multiple 
users are active on the same frequency, there can be no mistake to whom 
the report is intended. This format works extremely well.  Consequently 
when I change from FSK441 to JT65B and then later back to FSK441, I lose 
the local template format as it reverts to the default and subsequently 
have to re-enter the local template. I notice WSJT 9.7 did not have this 
issue.

Would it be possible to add a 'Region 3' template as per LZ2HV's FSK441 
software, 'MSHV'?

Allan
VK4QG


------------------------------------------------------------------------------
Monitor 25 network devices or servers for free with OpManager!
OpManager is web-based network management software that monitors 
network devices and physical & virtual servers, alerts via email & sms 
for fault. Monitor 25 devices for free with no restriction. Download now
http://ad.doubleclick.net/ddm/clk/292181274;119417398;o
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel

Reply via email to