On 14/09/2015 14:50, Jay Hainline wrote: Hi Jay, > Hello Bill. I have WSJTX CAT configured for the Yaesu FT-2000 now and with > split operation set to Rig, It is functioning correctly. So it must be an > issue with DXlabs Commander. OK. You didn't confirm if Commander went to split mode, that would help to isolate the issue.
Also, have you tried using Commander with "Fake It" split operation, that doesn't use split mode but makes VFO changes "just in time" to do the same thing. > > 73 Jay > > Jay Hainline KA9CFD > Colchester, IL EN40om 73 Bill G4WJS. > > -----Original Message----- > From: Bill Somerville > Sent: Monday, September 14, 2015 13:37 > To: wsjt-devel@lists.sourceforge.net > Subject: Re: [wsjt-devel] CQ Rx bug > > On 14/09/2015 14:07, Jay Hainline wrote: > Hi Jay, >> I build WSJTX 1.6.1 r5892 from sourceforge this morning. Using a Yaesu >> FT-2000 and DXLabs Commander for CAT. I have 50.280 set in the Working >> Frequencies list for JTMSK mode. When I put a checkmark in the box to >> activiate the CQ RX 285, the radio goes to 50.285 as it should. But when I >> Enable Tx to CQ, the radio stays on 50.285 instead of switching back to >> 50.280 on transmit. It makes no difference if I have split operation set >> to >> none or Rig in the settings and the Rx frequency offset with "CQ nnn..." >> is >> check marked. > Did Commander and your rig go into split mode? > > As a sanity check can you try the same test with Commander not running > and WSJT-X configured to talk directly to your rig please? >> 73 Jay >> >> Jay Hainline KA9CFD >> Colchester, IL EN40om > 73 > Bill > G4WJS. ------------------------------------------------------------------------------ _______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
