Hi Bill.
Well, I use two independent setups, one with a TS590S and transverter for 2m
and another TS590S for 6m. I toggle between the two in the one instance of
WSJT-X (currently v1.7.0-rc3 r7363). I find that when I change the radio and
audio parameters, WSJT-X gets confused. Sometimes this gets resolved by
exiting WSJT-X and restarting.
I thought that the "configurations" menu would allow me to store the two
different environments/ configurations but I have been unable to make this work
in a useful way. I tried reading the manual but couldn't find anything useful
in there on the subject. Perhaps I missed it?
Bill / AI5I
________________________________
From: Bill Somerville <[email protected]>
Sent: Sunday, December 11, 2016 2:40 PM
To: [email protected]
Subject: Re: [wsjt-devel] WSJT-X : use with transverters
On 11/12/2016 21:17, Patrick wrote:
> When the program starts, it is set as in the 10m band, so I have to move
> to the 2m band manually. It looks like WSJT-X reads the frequency (10m
> band) and setup the program accordingly without taking any notice of the
> transverter.
Hi Patrick,
WSJT-X follows the rig and does not know when you have the transverter
switched in, as far as it is concerned it assumes that a rig reporting
28MHz is receiving and transmitting on 10m. Once you select a 2m
frequency the offset is applied - the offset is stored against the 2m
band - so at that time your rig is expected to be the IF for your
transverter and applies the required up and down conversions to the
displayed frequency.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Developer Access Program for Intel Xeon Phi Processors
Access to Intel Xeon Phi processor-based developer platforms.
With one year of Intel Parallel Studio XE.
Training and support from Colfax.
Order your platform today.http://sdm.link/xeonphi
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
wsjt-devel Info Page -
SourceForge<https://lists.sourceforge.net/lists/listinfo/wsjt-devel>
lists.sourceforge.net
Your email address: Your name (optional): You may enter a privacy password
below. This provides only mild security, but should prevent others from messing
with ...
------------------------------------------------------------------------------
Developer Access Program for Intel Xeon Phi Processors
Access to Intel Xeon Phi processor-based developer platforms.
With one year of Intel Parallel Studio XE.
Training and support from Colfax.
Order your platform today.http://sdm.link/xeonphi
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
