On 16/12/2016 11:53, Bill Somerville wrote: > I assume you are referring to the percentage shown in the left hand Rx > status bar indicator while using MSK144 mode. This is an estimation of > CPU utilization so you can tune your receive parameters so as not to > overload the CPU. The "Menu->Decode->Fast/Normal/Deep" settings and the > FTol settings will impact CPU load and the intention is that you choose > settings that keep the figure less than 90%. When the utilization is > estimated as higher than 90% the background turns red, this is an > indication that too much work is being attempted and the decoder is not > keeping up with incoming audio. When this happens you should either > reduce the FTol value or switch to "Normal" or "Fast" in the > "Menu->Decode" pop up menu.
Sorry Dmitry, Oops, didn't read before writing! Right advice for a completely different problem. 73 Bill G4WJS. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
