In the WSJT-X rig selection you use "Hamlib NET rigctl".
First, start rigctld-wstx like you did before. When you select the rig as
above you'll see it connect and messages start flowing.That's the capture I
need...you'll probably want to send it as an attachment as it can get quite
long.
de Mike W9MDB
From: Pino Zollo <pinozo...@gmail.com>
To: wsjt-devel@lists.sourceforge.net
Sent: Tuesday, February 28, 2017 6:57 PM
Subject: [wsjt-devel] IC-7300 control lost
El 28/02/17 a las 21:49, wsjt-devel-requ...@lists.sourceforge.net escribió:
> You need to run WSJT-X using Hamlib NET rigctl and re-run this until it fails.
> de Mike W9MDB
Hi Mike,
it is not clear to me....
please which commands shall I give ?
73
Pino ZP4KFX
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
