On Tue, Jul 11, 2017 at 11:09 AM, Seb <w...@miamisky.com> wrote:
> I am seeing the same problem (at least with FT8), Enable Tx goes out after
> logging a QSO. I do NOT have Disable Tx after sending 73 enabled.
I believe this was the intended behavior; from an email yesterday:
On Mon, Jul 10, 2017 at 9:52 AM, Joe Taylor <j...@princeton.edu> wrote:
> 3. When your QSO finishes, another CQ transmission should be queued up, but
> "Enable Tx" will be off. To continue running a frequency you must click
> "Enable Tx" again.
Otherwise your machine could theoretically just keep replying as long
as someone responds to a CQ at least once every 6 minutes. While that
might be nice for WAS/DXCC...
--
Steve Huston - W2SRH - Unix Sysadmin, PICSciE/CSES & Astrophysical Sci
Princeton University | ICBM Address: 40.346344 -74.652242
345 Lewis Library |"On my ship, the Rocinante, wheeling through
Princeton, NJ 08544 | the galaxies; headed for the heart of Cygnus,
(267) 793-0852 | headlong into mystery." -Rush, 'Cygnus X-1'
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
