Rig controlled split operation does not work for a TS-590SG using Ham Radio
Deluxe. It will momentarily work (rig in split and WSJT-X rig control indicator
green with an S) but will drop out of split both on the rig and the indicator
in WSJT-X after a second or two (and after first transmit.)
This happens when using Ham Radio Deluxe connected to the rig, selecting "Ham
Radio Deluxe" in WSJT-X for the Rig and using "Rig" for split operation.
When "Fake it" is selected the WSJT-X rig control indicator shows green and an
S but the rig does not actually change frequency on transmit although the
frequency indicator in WSJT-X does show a frequency change (rig does not change
frequency)
When HRD is disconnected and WSJT-X rig control is set to the Kenwood TS-590SG
all works as it should (split functions properly). The issues arises only when
WSJT-X connects through Ham Radio Deluxe. When WSJT-X connects directly to the
rig split functions properly.
This also occurs with prior versions of WSJT-X and HRD.
Current Setup:WSJT-X v1.8.0-rc1Rig: Kenwood TS-590SGHam Radio Deluxe
6.4.0.664Rig connected to computer via USB portWSJT-X settings on the Radio
Tab: Rig:"Ham Radio Deluxe"Poll Interval: 1sPTT Method: CATTransmit Audio
Source: Rear/DataMode: USBSplit Operation: Rig
Thanks for any insight on this small issue for a great piece of software.
Chip -- KM4AF
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
