On 02/09/2017 16:32, Rick wrote:
When changing configurations (say from FT8 to MSK144), I've found that
the frequency does not change unless you go and reselect the desired
mode in the MODE drop down menu.
Hi Rick,
which of the options "Settings->General->Monitor off at startup" and
"Settings->General->Monitor returns to last used frequency" do you have
checked? These control what happens at startup which is what effectively
happens when you switch to a new configuration. Obviously the settings
in the configuration switched to are the pertinent ones.
Note that there is a trade off here, either WSJT-X takes control and
sets the frequency of your rig on startup or it remains passive and
waits for you to select a band or mode. You have control of this
behaviour with the above options.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
