Hello Joe,
I have just tried your suggested method, if I then go to the
configuration menu and press okay, when it returns to the main interface,
the rig reverts to the SET frequency for the WSJT mode selected.
eg. on WSPR, 144.489 if I type into the box as you suggested (not tried
that before I must admit), my test frequency was 144.085 which moved the
rig all okay, then if I open the settings menu and close I am now set back
to be on 144.489. This is the behaviour I would like to be able to
temporarily supress but still be able to use PTT via CAT.
Regards,
Peter, vk5pj
On Fri, Mar 16, 2018 at 11:19 PM, Joe Taylor <[email protected]> wrote:
> Hi Peter,
>
> On 3/16/2018 1:28 AM, Peter Sumner VK5PJ wrote:
>
> I would like to see if it would be possible to include a toggle on the
>> main GUI that stops WSJT-X sending frequency set commands to the
>> transceiver.
>>
>
> I do manual QSYs all the time when using WSJ-X on VHF bands. It's as
> simple as typing the desired new frequency into the band-selector drop-down
> control. For example, I might type "50.285" (or abbreviated as "285k")
> into this window to escape a birdie on 20.260.
>
> Doesn't this capability address your problem?
>
> -- 73, Joe, K1JT
>
>
>
> ------------------------------------------------------------
> ------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> wsjt-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
>
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
