The fix for the LotW error: Does that have to be done before you
download Ver 2.0 or can it be done after download? I upgraded to ver2.0
and ignored all warnings and pronouncements and it worked fine. I turned
on Monitor and was shocked how many decodes there were (80m). Every CQ I
answered someone came back. I called CQ and there were many replys.
Maybe I am imagining things but my FT8 success rate seems to be higher
then normal. Maybe everyone who upgraded is anxious to try Ver2 out as
much as possible because it is new?
I use DX keeper for logging ( I input the data manually) and it uploads
to LotW ok.) Am I missing something here? Is there and automatic way to
get data into DX Keeper that gets screwed up if you don't download the
fix? I am little shy about adding this extra file to my system for fear
it will break something else.
I am always perplexed about different operating styles with FT8. Some
only reply with signal reports. Some use auto sequence, some don't
answer with my report until the 3rd time or never. What gives?
Thanks-Great job Team
.
Ron K2PSD
On Tue, Dec 11, 2018 at 02:53 PM, Joe Taylor wrote:
On 12/11/2018 2:25 PM, Greg Gilbert KN4APC wrote:
What is the fix for this?
Thanks,
Greg KN4APC
New Year's Resolution:
"Before posting a question on setup or usage of WSJT-X I will check
the WSJT-X 2.0 User Guide and look for similar queries on the same
reflector."
In this particular case, an installation problem under Windows, try
looking at Section 3.1, "Installation: Windows":
http://www.physics.princeton.edu/pulsar/K1JT/wsjtx-doc/wsjtx-main-2.0.0.html#INSTALL
--Joe, K1JT
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
