Hi Denis, Being in French, it is a bit tricky here to understand all
parameters, but most are obvious.
My recommendation for PTT ;
Use the standard comport and RTS, See device manager, and id the CP2105
standard comport,
The other enhanced CP2105 comport that you are using now is only used
for CAT and not also ptt.
So you understand the usb connection uart-usb serial provides both these
comports as you see in device manager.
The advantage now is that on radio > FUNC > General > CAT RTS can be
turned off, set to OFF.
This is important when using VSPE splitter to share the CAT comport to 4
programs.
The VSPE program should have all options for RTS/DTR turned off or
cleared ( < @ Brian note).
The wsjtx split should be Rig and the mode should be Data-U (pkt) for
best TX signal results.
The split SUB TX will keep SUB vfo lower to maintain TX audio frequency
as you TX to the left of PAN.
In wsjtx 2.3.0 rc1 the FTDX101 split indicator now works on Rig split
and the SUB set for TX cycle.
In 2.2.2 the SUB was doing the TX cycle however the split indicator was
not lit.
For JTDX , the author again will need to update to resolve your issue.
If members of the wsftx development group could pass to JTDX it would be
appreciated.
On 31/10/20 1:33 am, f8nhf wrote:
hello to all
problem in FT8 / FTDX101D with HRD and JTDX
after switching to transmission the SUB button does not return to the
MAIN position
thank you for your help
73 F8NHF Denis
_._,_._,_
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
