HI Mike !
No error reported. Frequency just stays on where it was set by "monitor
returns to last used frequency". No change, no error.
I do not see any connection of File/Settings/Frequencies and rig
polling. It should read what rig display has in not depending on what is
in band selector frequencies list.
Dial -200 is not bad idea.
Then you can set your tx to be 150Hz that is usually empty. I guess most
(specially old) rigs can pass that, but they do not hear calls over
2500Hz that leaves 2500Hz-3400Hz unusable.
By experience below 200Hz reaches most stations while 2.5-3.4kHz fails
more often.
--
Saku
OH1KH
Black Michael via wsjt-devel kirjoitti 3.8.2021 klo 16.10:
WSJT-X most certainly does poll the rig. Though only every 5 seconds
since you set it that way.
Of course it won't poll if it gets an error.
Perhaps you need to reset your frequencies in
File/Settings/Frequencies -- right-click in the list and "Reset".
And dialing down to get "free tx space" below 200 is a bad
idea....most everybody won't hear you down there as it's below their
bandwidth cutoff.
Mike W9MDB
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
