"When using the signalink, the audio goes through the data port. You
must select VOX for the rig to use audio on this port. Using CAT will
not send audio from the data port. It will key the rig, but wont
modulate because its looking for audio on the mic connector only "
Not here;
Mine uses the data jack audio as setup above with both my 857 and 897
(same electronically),
and have never needed to use vox. Do you have rear audio source selected
like above ?
vk4tux
*From:* Adrian <vk4...@gmail.com>
*Sent:* Sunday, July 10, 2022 10:31 AM
*To:* WSJT software development <wsjt-devel@lists.sourceforge.net>
*Cc:* Nigel Haynes <supernigel.hay...@gmail.com>
*Subject:* Re: [wsjt-devel] FT-857 rig control bug in WSJT-X 2.6.0-rc1
The cat port doesn't have any audio connections. The
signal-link should be using the data port. Do you have a cat
cable fitted as well ?
I have 897/857 setup for wsjtx with no need for vox using cat
ptt, but I do have both CAT and data(sndcd) lines fitted.
73
vk4tux
On 11/7/22 00:22, Nigel Haynes via wsjt-devel wrote:
cat port on the rear where the signalink is sending the audio
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
