Google: rpi starting an app on boot
I found quite a few articles explaining multiple ways to accomplish it. On Tue, Feb 5, 2019 at 8:17 AM Curt Mills <[email protected]> wrote: > From page 13 of the TNC-Pi manual: > > "Set the transmit delay > > The transmit delay (TXDelay) can be set either in software or using R6. > The default is to set it in software. To change the TXDelay parameter, > you'll need to use the pitnc_setparams program as explained below in the > section, Using Xastir. If you set the value of TXDelay to 0 using the > pitnc_setparams program, you can then use R6 to set the TXDelay. Most users > will find the default setting for TXDelay to be just fine." > > > On Tue, Feb 5, 2019 at 7:58 AM Jim Darrough <[email protected]> wrote: > >> I've seen this mentioned a few times, but I need to get current and >> appropriate input on how to start Xastir upon boot of the RPi. >> >> Also have a question on how to set transmit delay so that the >> transceiver has time to develop power before the data stream starts. On >> a KPC3+ this was done by setting TXD to 60. Not at all sure how to do >> with RPi3/Pi-Tnc/Xastir. >> >> Thanks for any comments. >> >> 73 Jim Darrough, KI7AY EM25pd >> >> -- >> 73 Jim,KI7AY >> la ciruela de Panama >> >> _______________________________________________ >> Xastir mailing list >> [email protected] >> http://xastir.org/mailman/listinfo/xastir >> > > > -- > Curt, WE7U http://we7u.wetnet.net > http://www.sarguydigital.com > -- Curt, WE7U http://we7u.wetnet.net http://www.sarguydigital.com _______________________________________________ Xastir mailing list [email protected] http://xastir.org/mailman/listinfo/xastir
