OK, after many suggestions and to avoid a full reset (something I'm not quite ready to do), I took a second look at the special Kenwood command mode and got things to work. So here's my tnc-startup.d700.9600 I'll write up a readme to go with it later.
# $Id: tnc-startup.d700,v 1.6 2005/01/08 09:19:32 we7u Exp $ # # Copyright (C) 2004-2005 The Xastir Group # # TNC Init file for KENWOOD D700 # # NOTE: TXD on a D700A is fixed at 500ms (1/2 second) in "APRS" # mode. In "packet" mode we can change the txd to other values. # # #Don't send CONTROL-C before this line ##META <no-ctrl-c> TC 1 ##Pause for one second ##META <delay> ##META <delay> # Turn off APRS mode beaconing now so we don't beacon an old position when we exit packet mode # NOTE: you will have to manually turn beaconing back on if you leave this command enabled ##META <no-ctrl-c> BCN 0 ##Pause for one second ##META <delay> ##META <delay> #Put the TNC in packet mode since this is where we want to end up # Change the 1 to 0 to go to normal radio mode ##META <no-ctrl-c> TNC 2 # Pause for two seconds ##META <delay> ##META <delay> ##META <delay> ##META <delay> #Force 9600 baud packet ##META <no-ctrl-c> PKSA 1 ##Pause for one second ##META <delay> ##META <delay> # Enable 4800 baud GPS # Change to 2 for 9600 baud GPS # Disable both the META line and the GU line for no change ##META <no-ctrl-c> GU 1 # Pause for two seconds ##META <delay> ##META <delay> ##META <delay> ##META <delay> #Turn off Terminal Control ##META <no-ctrl-c> TC 0 # Pause for two seconds just in case ##META <delay> ##META <delay> ##META <delay> ##META <delay> HID off #CWID off AWlen 8 BBSMsgs ON B E 0 LOC E 0 Echo off FLow off AUTOLF off MCOM off MON ON MRPt on PACLen 128 PASSALL off #HBAUD 1200 TXDELAY 25 # Delete following lines if without GPS GBAUD 4800 GPSTEXT $GPRMC LTMH OFF LTM 10 # _______________________________________________ Xastir mailing list [email protected] http://lists.xastir.org/cgi-bin/mailman/listinfo/xastir
