Hi Stephen,
I have also experienced similar issue with HS23 IBM Blade,
we have got the solution,
Step1) set the eth2 install nic in noderes table
Step2) getmacs compute or all (what ever group you have)
Step3) After getting or collecting mac address change install nic to eth0 in
noderes table
Step4) rinstall node
Regards
Syed Asif Zaheer
From: Jarrod Johnson <[email protected]>
To: xCAT Users Mailing list <[email protected]>
Date: 06/15/2012 08:08 AM
Subject: Re: [xcat-user] IBM HS23 Blades
I can't remember the version, but at one point we made it so you can leave
installnic/primarynic blank, and we'd autodetect based on whet PXE booted.
With HS23, the on-board 10 Gb ports add some degree of surprise in how
they interact with the two on-board gigabit interfaces.
On Thu, Jun 14, 2012 at 3:29 PM, Stephen Fralich <[email protected]> wrote:
I'm trying to set up some new HS23 blades to boot a stateless image. The
issue I'm running into is that xcat sees the boot interface as eth0, but
Linux sees the boot interface as eth2. What I mean is if I set installnic
and primarynic to eth2, getmacs retrieves the wrong mac address. If I set
them to eth0, it retrieves the correct mac address, but then dhcp fails in
the initrd because it's trying eth0. I'm running an older version of xcat,
2.5.1, but I looked through the wiki and see no mention of hs23. Anyone
have any experience with xcat and hs23s? Thanks,
Stephen
------------------------------------------------------------------------------
Live Security Virtual Conference
Exclusive live event will cover all the ways today's security and
threat landscape has changed and how IT managers can respond. Discussions
will include endpoint security, mobile security and the latest in malware
threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/
_______________________________________________
xCAT-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/xcat-user
