Hi,
I suppose you modify the chain attribute after deploy the object node.
In that case, you shall run 'nodeset <nodename> runcmd=bmcsetup' to do the BMC setting up process.
Pls let me know if there is any more concerns.
Thx!
Best Regards,
-----------------------------------
Zhao Er Tao
IBM China System and Technology Laboratory, Beijing
Tel:(86-10)82450485
Email: erta...@cn.ibm.com
Address: 1/F, 28 Building,ZhongGuanCun Software Park,
No.8 DongBeiWang West Road, Haidian District,
Beijing, 100193, P.R.China
-----------------------------------
Zhao Er Tao
IBM China System and Technology Laboratory, Beijing
Tel:(86-10)82450485
Email: erta...@cn.ibm.com
Address: 1/F, 28 Building,ZhongGuanCun Software Park,
No.8 DongBeiWang West Road, Haidian District,
Beijing, 100193, P.R.China
----- Original message -----
From: Nicolas Roosen <nicolas.roo...@hpe.com>
To: <xcat-user@lists.sourceforge.net>
Cc:
Subject: Re: [xcat-user] bmc setup with fixed IP addresses
Date: Thu, Jun 22, 2017 3:43 PM
Hi,
On 06/21/2017 06:55 PM, Jarrod Johnson wrote:
> If you nodeset <node> shell
> Then boot it, ssh in and run bmcsetup by hand, the output may be informative as to why the BMC didn't get set up correctly.
>
Practical. So the bmcsetup while run into the shell did successfully set
the correct IP address.
My guess is that the bmcsetup command is not run during the provisioning?
How can I check that?
Thanks.
Nicolas
> -----Original Message-----
> From: Nicolas Roosen [mailto:nicolas.roo...@hpe.com]
> Sent: Wednesday, June 21, 2017 11:50 AM
> To: xcat-user@lists.sourceforge.net
> Subject: [xcat-user] bmc setup with fixed IP addresses
>
> Hello,
>
> I'm in the process of installing a cluster of Supermicro x86_64 nodes with xCAT (CentOS 7.3).
>
> I created a single node (manually with mkdef and nodeset), can install it successfully.
>
> But one thing doesn't work for me: the setup of the BMC ip address.
>
> In our setup the BMC is shared over the first Ethernet interface. So I've declared a DHCP dynamic range, all BMC's get an IP address.
>
> Then I need to change this dynamically obtained BMC IP address in a static one (which is in a different subnet).
>
> So I though that simply adding into the node definition the BMC ip address and setting a [chain="runcmd=bmcsetup"] was enough.
> But it seems that this is not the case.
>
> How can I automatically change the BMC ip address while provisioning a node?
>
> Thanks.
> Nicolas
>
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
xCAT-user mailing list
xCAT-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/xcat-user
------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________ xCAT-user mailing list xCAT-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/xcat-user
