Hi Jan et al.!

Jan Kiszka wrote:
[...]
+modprobe xeno_16550A ioaddr=<io1>[,<io2>...] irq=<irq1>[,<irq2>...]
+                     [tx_fifo=<len1>[,<len2>...]] [start_index=<index>]
+
+Arguments:
+    ioaddr<N>   - I/O address of device <N> (e.g. 0x3f8 for ttyS0)
+    irq<N>      - interrupt number of device <N> (e.g. 4 for ttyS0)
+    tx_fifo<N>  - Transmitter FIFO size in bytes of device <N>, default is 16
+    start_index - First device instance number to be used, default is 0


If I may throw in my 2 eurocents:
I think the Arguments-section is a bit misleading.
One doesn't specify ioaddr1, ioaddr2 etc. on the command line, as suggested
by ioaddr<N>, but ioaddr=[1.dev],[2.dev]...
Same for irq and tx_fifo.

What about this:

Arguments:
    ioaddr      - I/O addresses of devices (e.g. 0x3f8 for ttyS0), separated by 
comma
    irq         - interrupt numbers of devices (e.g. 4 for ttyS0), separated by 
comma
    tx_fifo     - Transmitter FIFO sizes in bytes of devices, default is 16, 
separated by comma
    start_index - First device instance number to be used, default is 0 => 
rtser0

Just trying to make it as clear as possible :-)

Best regards,
Hannes.

_______________________________________________
Xenomai-core mailing list
Xenomai-core@gna.org
https://mail.gna.org/listinfo/xenomai-core

Reply via email to