On 01/18/2012 10:09 PM, Manuel Vonthron wrote:
> Dear all,
>
> I am using the driver "xeno_16550A" for serial communication between a
> powersupply and its controlling PC (x86). I started working with Xenomai
> 2.5.5, but I recently switched to another machine where I installed Xenomai
> 2.6.
>
> On this new machine, I get the "Inappropriate ioctl for device" error while
> setting up my serial connection:
> err = rt_dev_ioctl(fd, RTSER_RTIOC_SET_CONFIG, &serial_config);
> >> error -25: Inappropriate ioctl for device
> The following reads/writes don't fail but without proper configuration,
> messages aren't understood by the device.
>
> My tests with non-RT code and the regular Linux driver keeps working with
> this new machine and again, the RT code is the very same, I only updated my
> Makefile to match the new version.
>
> - setserial infos:
> /dev/ttyS0 uart 16550A port 0x03f8 irq 4 baud_base 115200 spd_normal
> skip_test
> - xeno_16550A loaded with:
> `modprobe -v xeno_16550A io=0x03f8 irq=4 baud_base=115200`
> - result of "rtdm" unit test:
> SetupExclusive openSuccessive openDefer close by driver handlerDefer
> close by pending referenceNormal closeDeferred module unload#
>
> Do you have any idea where the error comes from and how would I fix it?
It could be due to the version of gc. Try passing
CFLAGS="-fno-omit-frame-pointer"
on configure commande line.
--
Gilles.
_______________________________________________
Xenomai-help mailing list
[email protected]
https://mail.gna.org/listinfo/xenomai-help
