Hi > device should probably be /dev/mouse. But as to the 800x600 > problem: > > (II) TRIDENT(0): Clock range: 12.00 to 45.00 MHz > (II) TRIDENT(0): Not using default mode "800x600" (bad mode > clock/interlace/doublescan) > (II) TRIDENT(0): Not using default mode "800x600" (bad mode > clock/interlace/doublescan) > (II) TRIDENT(0): Not using default mode "800x600" (bad mode > clock/interlace/doublescan) > > It's looks like none of your 800x600 modes fall within > the clock range. I'm not sure why that would happen because I > clearly see modes builtin to the server (at least in 4.3 servers) > that fall within that range. You most likely have bad modes > in the XF86Config file. > > Here are some valid modes I generated with the "gtf" program > that comes with XFree86. I don't have the prgram "gtf". Is it important?
> # 800x600 @ 60.00 Hz (GTF) hsync: 37.32 kHz; pclk: 38.22 MHz > Modeline "800x600_60.00" 38.22 800 832 912 1024 600 601 604 622 -HSync +Vsync > > # 800x600 @ 69.00 Hz (GTF) hsync: 43.12 kHz; pclk: 44.85 MHz > Modeline "800x600_69.00" 44.85 800 840 920 1040 600 601 604 625 -HSync +Vsync > > The 60 Hz mode is close to the one builtin to the server. The 69 Hz > one is about the highest refresh rate you can get and still keep > within the video card's clock limits. Though things may look fuzzy > up there and a 65 Hz mode like below might look better: > > # 800x600 @ 65.00 Hz (GTF) hsync: 40.49 kHz; pclk: 42.11 MHz > Modeline "800x600_65.00" 42.11 800 840 920 1040 600 601 604 623 -HSync +Vsync None of them is working, I still get the same error message (this is why I don't post my log file again). I really have no idea any more now. Thanks for your ideas. Stephan _______________________________________________ XFree86 mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xfree86
