Dear Andreas,
If you use the command line, the information will be lost if you quit X. If
you want to save these changes, you must write them as options in xorg.conf
manually.
Thanks!
Best wishes,
Gordon
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Andreas Juch
Sent: 2009年4月1日 21:21
To: [email protected]
Subject: Re: General ATI TV-out problem with PAL B/G?
Am Mon, 30 Mar 2009 10:00:49 -0400
schrieb Alex Deucher <[email protected]>:
> On 3/30/09, Andreas Juch <[email protected]> wrote:
> > Ok. I have a RV350 (Mobility Radeon 9600 M10) so this would explain
> > the bad picture on the tv. Thanks for the info!
> >
>
> That chip should work fine. What version of the driver are you using?
> PAL support was broken until 6.9.0.
Hi!
I'm using version 6.10.0 which I compiled from the Debian experimental
package for my Debian lenny system.
The commands I use for turning the S-video output on are:
~~~
xrandr --output S-video --set load_detection 1
xrandr --addmode S-video 800x600
xrandr --output S-video --set tv_standard pal
xrandr --output S-video --mode 800x600 --right-of LVDS
~~~
After doing that, xrandr says:
~~~
Screen 0: minimum 320 x 200, current 2080 x 800, maximum 2080 x 800
VGA-0 disconnected (normal left inverted right x axis y axis)
LVDS connected 1280x800+0+0 (normal left inverted right x axis y axis)
0mm x 0mm 1280x800 60.1*+ 60.0
1280x768 60.0
1024x768 60.0
800x600 60.3
640x480 59.9
S-video connected 800x600+1280+0 (normal left inverted right x axis y
axis) 0mm x 0mm 800x600 59.9*+ 60.3
~~~
The relevant lspci-line is:
~~~
01:00.0 VGA compatible controller: ATI Technologies Inc RV350 [Mobility
Radeon 9600 M10]
~~~
I pasted the Xorg.log to http://pastebin.com/m1a509848. The steps I did
were: Turn TV on with the commands above, switch to VT and again the
commands from above.
Best regards,
Andreas Juch
_______________________________________________
xorg mailing list
[email protected]
http://lists.freedesktop.org/mailman/listinfo/xorg
