On Friday 22 March 2002 05:32 pm, Mark Vojkovich wrote: > On Fri, 22 Mar 2002, Tom Panning wrote: > > I just got a KDS AV-195TF monitor, and I have it running at 85Hz. The > > manual says: > > > > To use the full potential of this product, it is necessary to first set > > the video circuitry of the computer according to the maximum capabilities > > of this monitor. > > This can be expressed in any of the following ways: > > 1920 X 1440 73Hz > > 1600 X 1200 87Hz > > 1280 X 1024 120Hz > > 1024 X 768 130Hz > > 800 X 600 160Hz > > 640 X 480 160Hz > > > > My question is: How do I get the monitor to run at 120Hz (I run at 1280 X > > 1024)? I've tried setting VertRefresh to 120, but X doesn't start, > > because it says it can't find any matching modes. > > There aren't any modes that high in the XFree86 modepool. > But, fortunately, you can make any mode you want, including goofy > stuff like 1024x1024. > > There are many modeline generators around, including one posted > to this list. See: > http://www.xfree86.org/pipermail/xpert/2001-October/012070.html > > There are alot a bunch listed on freshmeat: > > http://freshmeat.net/search/?q=modeline§ion=projects > > Just put the new modeline in the monitor section and reference > that in the "Modes" in the Section "Screen". > > I doubt there's much benefit to running a monitor at that > high of a refresh. I don't think most people can see flicker above > 85Hz. Additionally, as the frequencies get higher, things just > get fuzzier, so for the most part, that statement in the montior's > manual is BS. Image quality does not get better as the refresh > rate goes up. Both the monitor and the video card will be taxed > at their extents.
Actually, I want to do this because in a couple months I'm going to do stereo graphics with X. So in order to get 60Hz per eye, I'll have to get 120Hz overall. I looked at the programs, and I was wondering if anyone had any experience with any of them? I'd rather not screw up my monitor because I used bad software. Is there a reliable way to extrapolate other mode lines from known mode lines, or is it more complex than that? Thanks, Tom _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
