The "s3" driver does not yet support your card, the Trio64 V2 (DX or GX). However, I can hack up some support and send you a test driver to try sometime this week.
ani On Sun, 12 May 2002, NDQ wrote: > Hi all, > > I'm using RH7.2 (kernel 2.4.9) with XFree86-4.1 on S3 Triov64 card. It works fine. > When I try to install RH7.3 (XFree86-4.2.x): my card was detected OK, > the X server test during installation is OK. But after reboot, I can > not run X at all. When I type "startx", XFree86 gives me an error about > config file, which was created by RH installer. > > So I try Xconfigurator but NO LUCK because this program gives > me a core dump file :( > > I try play manually with XF86Config file with help of man page. > Unfortunatly, I have NOT the luck with this version of XF86. > X server does NOT WORK. > > The same errors were observed with config file of RH7.2. > > On this PC, with exactly the same hardware I have installed and > ran succesfully X mode with: > - RH5.2->RH7.2; > - Mandrake7.2->Mandrake8.2; > - SuSE-8.0; > - Connectiva 7.0; > - ASPLinux7.2,.... > > But now I can not with RH7.3 :( > > My config and log files can be viewed at: > > http://linux.nguyendai.org/XF86Config > http://linux.nguyendai.org/XFree86.0.log > > (I not attached them here because of their size :) > > Any ideas for help me PLEASE! > > Thanks in advance, > > PS: Sorry for my poor english! > -- > Nguyen-Dai Quy > http://Linux.NguyenDai.org > _______________________________________________ > Xpert mailing list > [EMAIL PROTECTED] > http://XFree86.Org/mailman/listinfo/xpert > _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
