You need to use the current CVS with this board. TVP3026 support has been added to the Permedia boards.
Alan. On Wed, Jul 03, 2002 at 02:19:06PM +0300, Atanas Ivanov wrote: > Hi, > May anyone help me for following problem: > I try to start X with configuration: > Permedia 3000 (DataExpert - www.dataexpert.com.tw) with RAMDAC TI > TVP3026, 4MB sRAM, Mandrake Linux 8.2 > System RAM 320MB. > During installation procedure graphic mode is suggested 640*480*16. But > after installation, I > may not configure it in some mode. I install XFree 4.2.0. DrakX > (Xconfigurator) detect this card as Permedia2, > but results is the same. I post in XF86Config-4 manuali ChipSet as ti_pm > and pm, also MemorySize, RamDAC as TVP3026, but > while X starts in log apair folowing : > > (==) GLINT(0): Write-combining range (0xe9000000,0x400000) > (--) GLINT(0): Attached RAMDAC is IBM 525 > (--) GLINT(0): This IBM RAMDAC is NOT supported by this driver, aborting > (II) UnloadModule: "glint" > (II) UnloadModule: "ramdac" > > But my RAmDAC is not IBM525, it is TVP3026. I read in source that my > RAMDAC is supported, but why IBM525 is hard coded, I don't understood. > Please help me! > > > _______________________________________________ > Xpert mailing list > [EMAIL PROTECTED] > http://XFree86.Org/mailman/listinfo/xpert _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
