On Mon, 2002-07-29 at 11:00, Ian Borg wrote: > > 1) whenever X-server starts it sends monitor in "suspend" state - i.e. > monitor losts signal from card for a few secs than restores it's state to > "normal" and all works ok including acceleration. it's very annying and i > coldn't figure out where stacks problem :-( Any idea ?
It's a feature, drivers are supposed to blank the screen during startup so you don't see garbage (or the session of someone before you, ...) > 2) even if i specify HorizSync&VertRefresh in monitor section of > XFree86Config file X-server ignores them and uses detected VESA parameters > so my highest vertical refresh rate is 85Hz although monitor is capable to > display 1024x765 in 120Hz (Flatron H:30-96kHz, V:50-160Hz). Is possible to > get higher refresh rates ? The X server doesn't have modes with higher refresh rates built in. The radeon driver in current CVS has an option "DDCModes" to use modes from the monitor. -- Earthling Michel D�nzer (MrCooper)/ Debian GNU/Linux (powerpc) developer XFree86 and DRI project member / CS student, Free Software enthusiast _______________________________________________ Xpert mailing list [EMAIL PROTECTED] http://XFree86.Org/mailman/listinfo/xpert
