Hi! When I insert the mmc card to zaurus, it gets properly detected and prints some info into console. Mounting reading/writing files works fine.
However when the card is removed (doesn't need to be mounted before), the removal is most likely not detected, so when I insert it again, no info is printed into console and moreover when I try to mount it zaurus goes into infinite loop printing: Buffer I/O error on device mmcblk0p1, logical block 9 mmcblk0: error -110 sending status command mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00 end_request: I/O error, dev mmcblk0, sector 257 Buffer I/O error on device mmcblk0p1, logical block 10 mmcblk0: error -110 sending status command mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00 end_request: I/O error, dev mmcblk0, sector 258 Buffer I/O error on device mmcblk0p1, logical block 11 mmcblk0: error -110 sending status command mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00 end_request: I/O error, dev mmcblk0, sector 259 Buffer I/O error on device mmcblk0p1, logical block 12 mmcblk0: error -110 sending status command mmcblk0: error -110 sending read/write command, response 0xb00, card status 0xb00 ... Related part of the .config: # # OTG and related infrastructure # # CONFIG_USB_GPIO_VBUS is not set # CONFIG_USB_ULPI is not set # CONFIG_NOP_USB_XCEIV is not set CONFIG_MMC=y # CONFIG_MMC_DEBUG is not set CONFIG_MMC_UNSAFE_RESUME=y # CONFIG_MMC_CLKGATE is not set # # MMC/SD/SDIO Card Drivers # CONFIG_MMC_BLOCK=y CONFIG_MMC_BLOCK_MINORS=8 CONFIG_MMC_BLOCK_BOUNCE=y # CONFIG_SDIO_UART is not set # CONFIG_MMC_TEST is not set # # MMC/SD/SDIO Host Controller Drivers # CONFIG_MMC_PXA=y -- metan _______________________________________________ Zaurus-devel mailing list Zaurus-devel@lists.linuxtogo.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/zaurus-devel
